小学5年级 - 说明文 阅读指导

　　Power switch
　　The power switch is located on the end of the curved handle.
　　To turn hand vacuum ON ( I ), press up.
　　To turn hand vacuum OFF ( 0 ), press down
　　Cleaning with flexible rubber contour nozzle
　　1. Turn hand vacuum OFF.
　　2. Remove hard nozzle by pressing down on
　　round nozzle release button.
　　3. Replace with flexible rubber contour nozzle by lining
　　up the bottom of nozzle to the bottom of the dirt
　　container. Pivot upwards until it snaps into place.
　　4. Make sure the nozzle has snapped securely
　　into place before using
　　Emptying the dirt container
　　Empty the dirt container after each use. A
　　full dirt container may reduce suction or
　　performance of vacuum.
　　1. Turn hand vacuum OFF.
　　2. Unplug hand vacuum from electrical outlet.
　　3. Press dirt container release latch down to
　　disconnect dirt container and filter assembly
　　from the unit.
　　4. Remove filter by grasping tabs on both sides
　　of filter frame and pulling away from the dirt
　　container. For best results, periodically tap
　　filter assembly against trash can to remove
　　dirt that has collected on the screen and
　　filter.
　　5. Empty dirt into trash can.
　　6. Replace filter assembly by aligning side
　　labeled “TOP” into top of dirt container.
　　Grasp filter tabs and press firmly to ensure
　　filter assembly is secure in dirt container.
　　NOT E: Make sure side of filter assembly
　　labeled "TO P" faces outward when inserting
　　filter assembly into dirt container.
　　7. Reattach dirt container to unit by aligning
　　bottom of dirt container to bottom of unit.
　　Pivot upwards and snap into place. Use one
　　hand to hold the unit and use the other hand
　　to clip the dirt container securely in place